Overview
The Hoymiles Flex-S3 Connection Cable S3-CC-EN25-200 (formerly HMS Connection Cable-EN25-200) is an AC connection cable for single-phase HMS microinverters: 3 x 2.5 mm² H07RN-F with 2.0 m between connectors, a current rating of 25 A at 55 °C and a minimum bending radius of 8 cm. Connection cables, trunk connectors and extension connectors build a custom AC trunk, which runs to the distribution board via a cable terminal connector and AC end cable.
Read the full description
The Flex-S3 cable system (formerly the HMS cable system) is the plug-and-play AC cabling for single-phase Hoymiles HMS microinverters. Its connectors are 2P+PE, 300 V and 40 A, IP68 and UL 94-V0, suitable for conductors up to 6 mm² and cable up to 16.5 mm outer diameter at -40 to +85 °C (IEC 61984); the connection cables are H07RN-F (450 V) in 2.5, 4 or 6 mm².
On 2.5 mm² Hoymiles specifies a maximum of 11 to 19 HMS-1T, 5 to 9 HMS-2T or 2 to 3 HMS-4T units per AC branch, depending on the power rating; always check local requirements. The same series also exists in 1.1 to 4.6 m lengths and in 4 and 6 mm².
Specifications
General
- Category
- Cabling
- Product code
- 42-143
- Manufacturer code
- HMS connection cable EN25-200
- Type
- HMS AC-aansluitkabel
- Model
- S3-CC-EN25-200 (voorheen HMS Connection Cable-EN25-200)
- Segment
- Residentieel
Electrical
- Connection
- Flex-S3-connector (IP68)
Mechanical
- Length
- 2 m
Other
- Ader
- 3 x 2,5 mm² H07RN-F
- Past bij
- Hoymiles HMS 1T/2T/4T
- Min. buigradius
- 8 cm
- Nominale stroom
- 25 A bij 55 °C
- Nominale spanning kabel
- 450 V
Questions
The short ones are here. For anything else, ask below.
The Hoymiles Flex-S3 Connection Cable S3-CC-EN25-200 (formerly HMS Connection Cable-EN25-200) is an AC connection cable for single-phase HMS microinverters: 3 x 2.5 mm² H07RN-F with 2.0 m between connectors, a current rating of 25 A at 55 °C and a minimum bending radius of 8 cm. Connection cables, trunk connectors and extension connectors build a custom AC trunk, which runs to the distribution board via a cable terminal connector and AC end cable.